Acurus A2005 Manual do Utilizador Página 6

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 12
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 5
Revision 3-26-2012 Page | 6
The response to each command is proprietary hex code used for Acurus Control system and should be ignored
by the external control system.
SEND CMD FORMAT: XX (XX is the Value in Hex, Decimal, or ASCII Symbol per table)
EXAMPLE
SEND CMD: 49 (49 – The Front Panel Brightness would be set to the low setting.)
The status check table is shown below:
STATUS TYPE
VALUE
(HEX)
VALUE
(DECIMAL)
ASCII
SYMBOL
RETURN
POWER STATE 70 112 p ON or OFF
SEND STATUS CMD FORMAT: XX (XX is the Value in Hex, Decimal, or ASCII Symbol per table)
EXAMPLE
SEND CMD: 70 (70 – The Power Status command.)
RESPONSE: ON (Return either “ON” or “OFF”.)
Web Based Control Specifications
The A2005/A2007 Audio Amplifiers contain a built in web server. Direct control and status monitoring tools are
located on the web page for the product. This feature is a great tool for diagnostic / setup of the product. This
interface will also auto optimize the user interface for mobile devices. All that is required is a device with a web
browser, a standard router, and an A2000 series amplifier. All controls for the product are available on the
amplifier Web Page.
To use the web interface: Visit the website for the amplifier.
http:// IP ADDRESS Example: http://192.168.1.240
Please refer the A2000 Series Amplifier User Guide for more details about how to discover and use the advanced Web
interface, via the Ethernet connection.
Ethernet Based Control Specifications
This amplifier is also designed to receive external control commands via the Ethernet port. All commands use
UDP Protocol (User Datagram Protocol) format for transmission over a standard IP network. A unique status
table is also available via XML format on the on the device. The Ethernet port on the amplifier should be
connected to the router. The external control system should also be connected to the same router via wired or
wireless connection.
Vista de página 5
1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários